Speedy not repaired after 5 months!
Allow me to to tell you my tale of woe and then I'd be grateful for any advice.Cast your mind back to 9th September last year. I'm on holiday and decide to treat myself to a new Speedmaster Pro from an AD in a city 300 miles from home. I have a very pleasant transaction with the salesman and receive a 12% discount. I'm happy.2 weeks later, I'm not quite so happy. The Speedmaster has a serious problem. After a full wind it dramatically gains time, 20 seconds in 5 minutes! I've also spotted a dent in the bezel. I refer back to a photo I took an hour after purchase which shows the ding, (at the 90 mark) but which took me 2 weeks to notice. I didn't dent my new watch.So with cosmetic and major mechanical faults, I agree with the AD to send it back to him. That was on the 29th September 2009.135 days later I've still not got it back on my wrist! The AD sent it to Omega and by mid-December it was back at his shop with the mechanical problem repaired. However Omega had refused to replace the

Life is like a box of chocolates, dark chocolates. You never know...
what you're gonna get

Small Question
WHo makes the best winder for PP?

About to pull the trigger on a PAM 233
But still a bit concerned that it might be too big for my 6.5ish wrist. Here are some wrist shots for ur reference. You guys can be honest, I'm a grown man. PAM 380 This watch is 45mm in diameter but much slimmer that Luminors with short wire lugs. BP FFAnother 45mm but with short lugs again. A Sub C for good measure. Thanks in advance. Sent from my iPhone using Tapatalk

Picking the right jubilee bracelet for my pre-ceramic (16710) GMT Master II
Hi all,I recently bought a 16710 GMT Master II, D serial (no lug holes), which came with the original oyster bracelet. Here it is:I'd like to buy a jubilee to have as an option with this watch. From what I've found searching TRF, I have three options:1) 62510H bracelet with 502T endlinks2) 63200 bracelet3) 63600 braceletIs that right? And is it true that 63200 and 63600 are pretty much the same except for greater # of removable links with 63600?All three options are expensive, and I'm not sure which one to get. #1 appeals to me because it is accurate for this particular watch and is probably lighter than the other two. #2 / #3 appeal because they have solid endlinks, and the clasp isn't stamped metal.Any other factors to consider? For those of you who have tried both, is there a significant difference in comfort between these options?